ST6001S – Serial Controller

Physical Characteristics Features ST6001S is the newest controller supplied by Generaltouch. • 6.6/10.4ms conversion time • Support size of touchscreens from 6.4’ to 22’ without jumper setting • Touch sensitivity can be adjusted in 5 levels • T mode and C mode data transmit Protocols • Operation temperature from -20°C to 70°C Construction • Multi-layer surface-mount design with internal ground plane for EMI suppression
Supply Voltage and Current • +12 VDC, nominal(+9 VDC to +15 VDC) • 86 mA, typical at +12 VDC. Average power dissipation is 1 W, typical. • Supply must be capable of sourcing 200 mA, minimum. • Total noise and ripple requirement must be less than 100 mV (p-p) for frequency below 1 MHz, and less than 50 mV (p-p) for frequencies above 1 MHz. Interface • EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex. Baud Rate • 9600 Operation Mode • Support T and C Mode Protocols (only ST6001S-H) • Support UP/STREAM/DOWN and Z Axis Modes Touch Resolution • 4096x4096, size independent, 256 levels of Z axis (pressure) Conversion Time • Approximately 6.6 ms (only ST6001S-H)/10.4 ms per coordinate set (including transmitting time)		Reliability • MTBF greater than 300,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground benign environment with an ambient temperature of 25°C. Flammability • The printed circuit board substrate is rated with 94V0. Environmental Temperature • Operating: -20°C ~70°C • Storage: -40°C ~ 85°C ESD • Per EN 6100-4-2 : Contact discharge 4kV, air discharge 8kV. Relative Humidity • Operating: 10% to 90%, non-condensing • Storage: 10% to 90%, non-condensing